|
|
Steel
Street Plate Lifting Hoist Rings |
|
The Street Street Plate Lifting
Rings and accessories allow for faster and safer handling
of heavy steel plates commonly used to temporarily
cover excavations in streets and roadways during construction
or repair.
The ring hoists come either rigid or in a swivel design. Each
design is popular by operators. The swivel hoist
ring can swivel 360 degrees and pivot 180 degrees.
Fabricated of heat treated, magnetic particle inspected
and certified 4140 aircraft quality, chrome moly steel. The
Street Street Plate Lifting Rings have a 5:1 safety
working load limit.
The Hoist Rings and Nuts are manufactured to work together
to ensure proper usage. The usage of commercially available
nuts probably will not meet the specific tolerances
required for lifting these heavy loads. |
Additional accessories available
are: Thread clean out tool, used to clean out dirt
or other foreign matter from the thread of nuts. Go/No
Go Gage, used to determine when street plate nuts and
studs need to be replaced. Rectangular and round
weldable plates, used to replace the center section
of street plates from prior usage which eliminates
the need to change the entire plate. |
| Rated capacity is for straight lifts. Any angle
lifts should be avoided. Hoist Rings Load limits
are reduced by as much as 80% on angle lifts! |
|
|
|
|
|
|
|
|
Copyright
© 2003 - 2012 All Rights Reserved: Construction And Rigging Supply,
Inc.
1427 Los Angeles Avenue, Ventura, CA
93004 |
805-647-4792 Office | 805-256-6477 Fax |
|